1 / Original configuration
Send exact manufacturer model, capacity suffix, drawing revision and calibration report. Verify whether the original sensor is static or rotary.
REACTIONTORQUE.COM / ENGINEERING
FUTEK, Honeywell & Interface Replacement Review
Request a drawing-led torque sensor alternative. Compare bolt circle, center bore, stiffness, cross-load limits and electrical interfaces before approval.
Approve mechanical fit and measurement behavior separately.
We offer an independent alternative review for FUTEK TFF / TAT / QTA, Honeywell QW / QWF, Interface TS / axial-torsion and HBM / Burster reference equipment. References are a starting point; they are not a declaration of an approved interchange.
2 / Interface comparison
Compare OD, BCD, thread, pilot, bore, height, stiffness, axial/bending limits, connector and cable exit.
3 / Electrical acceptance
Confirm excitation, mV/V, polarity, bridge resistance, pinout, shield, amplifier scaling, bandwidth and CW/CCW uncertainty.
Price, delivery and compatibility are quotation-specific. No competitor price, lead-time or saving percentage is guaranteed.
01 / MT-RTS-FLG
Flange-to-flange
0.5–5,000 Nm
Motor stator and valve actuator test stands02 / MT-RTS-JNTHollow robotic joint
1–500 Nm
Humanoid, exoskeleton and surgical robot joints03 / MT-RTS-SQSquare drive & hex
1–2,000 Nm
Torque-tool and fastener calibration fixtures04 / MT-RTS-SHFKeyed shaft
0.1–1,000 Nm
Bearing friction and low-torque component tests05 / MT-RTS-FZThrust + torque
1–1,000 Nm + 100 N–50 kN
Drilling, tapping and fastener preload correlationREQUEST QUOTE / CAD
Start with your load and mounting envelope.
Send the installation constraints. We will review the sensor configuration, drawing, calibration scope and commercial quotation.
Prefer email? inquiry@reactiontorque.com
Please send non-confidential specifications first. CAD is supplied for the agreed configuration after engineering review.